Question 6036 of 790 · California General Electrician Exam
After cutting EMT, what must be done to the cut ends?
Exactly one answer is correct.
You got of questions right. Here on the question pages nobody remembers which ones you got wrong. The trainer saves your progress and asks the mistakes again until they stick.
Or free: the 10 questions most people get wrong
Show solution
Correct answer to question 6036
- D: Ream or otherwise finish them to remove rough edges
Explanation
All cut ends of EMT must be reamed or otherwise finished to remove rough edges that could damage conductor insulation during pulling. See 358.28.
More questions: Wiring Methods, Conductors and Boxes
- 6037What is the maximum percent fill of a conduit containing three or more conductors?
- 6038A conduit nipple not exceeding 24 in long between boxes may be filled to what percent of its area?
- 6039When calculating conduit fill, how are equipment grounding conductors treated?
- 6040What volume allowance does the box fill table assign to each 12 AWG conductor?
- 6041In a box fill calculation, a single receptacle on one yoke counts as
- 6042Two equipment grounding conductors enter a box. How are they counted for box fill?