Question 1107 of 1003 · California General Electrician Exam
When a manufacturer specifies a tightening torque value for a terminal, NEC 110.14(D) requires the connection to be made with:
Exactly one answer is correct.
You got of questions right. Here on the question pages nobody remembers which ones you got wrong. The trainer saves your progress and asks the mistakes again until they stick.
Or free: the 10 questions most people get wrong
Show solution
Correct answer to question 1107
- B: A calibrated torque tool or other approved means
Explanation
110.14(D) requires that where a tightening torque is indicated as a numeric value on equipment or in the installation instructions, a calibrated torque tool be used unless the manufacturer allows another method.
More questions: Definitions, Theory and Plans
- 1108The required depth of working space in front of a 120/240-volt panelboard (150 volts or less to ground) is, for all conditions:
- 1109A 480Y/277-volt panelboard has exposed live parts on one side of the working space and a grounded concrete wall on the other (Condition 2). What is the minimum depth of working space?
- 1110Equipment at 277 volts to ground has exposed live parts on both sides of the working space (Condition 3). The minimum working space depth is:
- 1111What is the minimum width of the working space in front of electrical equipment covered by 110.26(A)?
- 1112For service equipment and panelboards, the minimum headroom of the working space is generally:
- 1113A homeowner stacks storage boxes in the working space in front of a panelboard. Under 110.26, this is: